Our other sites

Sabic’s bimodal HDPE hits the market

European Plastics News staff
Posted 22 February 2013

Sabic is preparing a plant in Gelsenkirchen, Germany, to produce bimodal HDPE for blow moulded bottle applications. Commercial production is due to start in the second quarter of this year.

“Some processors are concerned about future supply of bimodal HDPE grades from Europe, so we think this is the right time for us to support the market,” says spokesperson Mario Scholle.

The company is currently fine-tuning the grades and is already in talks with potential customers.

Initially, the Gelsenkirchen plant will supply two grades, both with a density of 0.958 g/cm3, and with melt flow rates of 22 and 28 g/10 min (21.6 kg) respectively

The same grades, as well as grades intended for jerry cans, drums and other large containers, will also be produced at one of the company’s plants in Saudi Arabia. Production there will start in the third quarter of 2013.


Tell us what you think

*Your Name:
Nickname: Company:
You can use a nickname if you wish to post anonymously.
Your real name and email address are still required.
*Email:
*Comment:


TOOLBOX

ALSO IN THIS SECTION
MOST POPULAR STORIES
Site Index [ + ]

Entire contents copyright 2014 by Crain Communications Inc.
European Plastics News and EuropeanPlasticsNews.com are published by Crain Communications Ltd (registered in England & Wales No. 01576350).
Registered Office: 100 New Bridge Street, London, EC4V 6JA, United Kingdom.